Rolling Ring Driver Installation Accessories:
There Are Four Holes In The Top Of The Rolling ring traverse drive Which Are Used To Fix The Accessories. The Bolts Shall Not Be Over Screwed So That The Apparatus Works Well. For The Deepness Of Threaded Holes See The Dimension Table Of Installation Md.
Roll Ring Traverse Unit Pitch Adjustment：
The Range 0-10 On The Pitch Selection Scale Is Used To Adjust The Traverse Pitch, By Pressing Down The Indicator To Separate The Positioning Tooth From The Scale And Then Move It To Adjust.
Free-Movement Lever：
The Free-Movement Lever Must Be In Loose State When Setting Up The Polished Shaft. If The Free-Movement Lever Is At O Position (Horizontal Position), The Rolling ring linear drive Motion Can Be Moved Freely To Locate The Start Point Of Wire Rolling Ring. If At 1 Position (Vertical Position), The Rolling Ring Linear Drive Motion Is In Normal Working Condition.
Rotation Direction Of The Polished Shaft Adjustment：
The Rotation Direction Of The Polished Shaft Is Related To The Position Of Reversal Wheel. The Down-Ward Rotating Of The Shaft Is Defined Positive Direction In The Face Of Pitch Selection Scale. When The Shaft Is Required To Be Reversal, Please Reinstall And Adjust The Position Of Reversal Wheel By 180°.
Smooth Shaft Drives Woking Thrust Adjustment:
There Are Two Pressure Adjusting Nuts On The Smooth Shaft Traverse Unit, One Is At The Top Center And The Other Is At The Bottom Right. A Slight Turning Will Adjust The Thrust Force. The Nuts Have Been Well-Adjusted, So Please Do Not Turn Them. If The Thrust Cannot Reach The Requirement Of Wire Rolling Ring Adjust The Two Nuts To Get The Appropriate One.
Roll Ring Traverse Drives Maintenance：
The Rolling Ring Traverse Drive Working Is A Precise Apparatus Which Has Een Well-Adjusted When It Leaves The Factory. Disassembly Is Not Allowed. No.20 Machine Oil Should Be Regularly Serviced On The Shaft When Be In Use To Keep The Work Surface Oiled. The Free-Movement Lever Should Be At 0 Position When Be Not In Use.
Rolling Ring Drives Pitch Error Adjustment：
When The Left Traverse Pitch Is Not The Same As The Right One, Loosen The Screw And Adjust The Eccentric Nut To Reach The Required Result. Then Fasten The Screw.
